Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Anson, TX

Haas Door Garage Door Roller Replacement in Anson, TX

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

Our Haas Door garage door roller replacement service in Anson, TX comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. We work on Haas Door garage doors of every age, from older models to current lines, and carry or can source compatible parts. Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Signs you need Haas Door garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Before the technician arrives

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Haas Door garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

Typical Haas Door garage door roller replacement prices

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Haas Door services

Local Haas Door garage door roller replacement for Anson, TX

Humid air in Texas rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Besides Anson (ZIP code 79501), we handle Haas Door garage door roller replacement in Stamford (14.1 mi), Hamlin (16 mi), Merkel (20.9 mi) and Abilene (23.3 mi). Call (833) 435-8883 to book a visit in Anson.

Haas Door Garage Door Roller Replacement: frequently asked questions

How much does Haas Door garage door roller replacement cost in Anson, TX?

Haas Door Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Haas Door garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Haas Door garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Haas Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Anson requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Anson, TX

Overhead Door Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

LiftMaster Garage Door Sensor Repair

LiftMaster is the professional-installer brand of The Chamberlain Group. The color of the learn button on the motor unit shows which remotes are compatible (yellow on Security+ 2.0 models; purple, red, orange or green on older ones), and most current models work with the myQ app.

Typical $100-$250

Overhead Door Remote & Keypad Programming

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $50-$150

Hörmann Smart Garage Door Opener Setup

Wi-Fi openers and smart hubs set up so you can open, close and monitor from your phone.

Typical $100-$900

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Hörmann Off-Track Garage Door Repair

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $175-$450

Holmes Garage Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Raynor Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Raynor Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Garaga Weather Seal Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $100-$300

Overhead Door Garage Door Sensor Repair

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $100-$250

Haas Door Garage Door Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Anson, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote